Jump to content

Banner.jpg.b83b14cd4142fe10848741bb2a14c66b.jpg

Altitude motor not working

NenoVento

By NenoVento
in Discussions - Mounts

 Share

Recommended Posts

NenoVento

NenoVento

Posted
  • Author
Posted

Maybe pictures could help us understand your problem because I’m not sure I am understanding it right. If the problem is to remove the lid of the base of fork after taking off all the screws, as @Cosmic Geoff said, you have to move It this way and that until It goes off, trying not to force It too much and damage It...

Link to comment
Share on other sites
  • Replies 25
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Tomatobro
Tomatobro

I have just read your post and tried to follow what you have done and it seems to me that swapping the connectors has eliminated the hand set and the board. Switching the drive output over tested the

symmetal
symmetal

Yes, as Tomatobro said, your connector swap indicates the problem is with the Dec motor or the cable connecting it to the board. Check that the individual pins on the Dec motor connector are fully pus

symmetal
symmetal

The two wires going to the motor body look as if they are soldered to tags on the motor and coverered with heatshrink so no they won't pull off. The wires going to the connector at the end of the moto

Posted Images

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.