The Obsey pt2, The re-build

[JemC]

The Obsey pt2, The re-build

This is not one of those diy builds from scratch that most people do, this is just the re-build of the Obsey i picked up from Essex last week,

Seeing as the weather was being nice this weekend i thought this would be a good time to re-build, 

Here it is all piled up ready to go,

Obsey site was already prepared and my pier was already in situ and not really feasible to remove it so i was going to have to work with that,

1st job i was going to have to do was cut a hole in the floor section to go over the pier, 
So i placed the floor section on top of the pier plate with the assistance of my helper, while we held in place i got the wife to crawl underneath and draw round the pier plate, (had to make sure there were no spiders)

hole cut and floor in place,

Now it's just a case of screwing the walls in place,

walls done, now the 1st roof section (the non-sliding bit)

I did have words about the bare feet,

Now to just fit the sliding sections, Rear section 1st

Then the front sliding section, plus the polystyrene inserts,

Here's a couple of small videos to show the roof sliding and the views i will have, Hope they work.

 

 

It will still be x number of weeks before it is fully operational, before i start to put my equipment in there i need to sort out the security side of things, also need to find some clamps/fixings to secure the roof from inside,
As it came with no door(it was joined to another shed and was accessed through that in it's old location) i also need to source one of those, plus a few other little tweaks and then it should be good to go.

Regards

 

[sloz1664]

Looking great so far. When complete and in use you will wonder how you coped without it.

Steve

[Astrokev]

Videos work fine

Looking good!