Jump to content

NLCbanner2024.jpg.2478be509670e60c2d6efd04834b8b47.jpg

Trying to source scope handle


Recommended Posts

14 minutes ago, johninderby said:

Use a hammer to tap one end off and then cut down the tube and rubber cover. The end can be a tight fit so may need some persuasion to drive it off. The end is really tough so won’t be damaged by a bit of hammering. Be careful when trimming the rubber covering as it’s easy to cut it too short. As they say  measure twice and cut once. 🙂

Ok, thanks will give it a try, it is very very tight....hope I don’t damage it... 😮😮

Link to comment
Share on other sites

2 hours ago, johninderby said:

Use a hammer to tap one end off and then cut down the tube and rubber cover. The end can be a tight fit so may need some persuasion to drive it off. The end is really tough so won’t be damaged by a bit of hammering. Be careful when trimming the rubber covering as it’s easy to cut it too short. As they say  measure twice and cut once. 🙂

Ok, used a wooden mallet and got it off....without any damage...thanks .... 👍😀

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.