Jump to content

Banner.jpg.b83b14cd4142fe10848741bb2a14c66b.jpg

C8 SCT Bolt help Please

Kai

By Kai
in DIY Astronomer

Recommended Posts

Kai

Kai

Posted
Posted

At the front of my C8 there is a bolt that i attach my ADM rail system to,the problem is that the supplied ADM bolt is about 3 turns too small and has started to pull out of the C8.

Now its only a simple bolt BUT i do not know the size,Its like a 5mm but with a coarse thread.

Can any of you confirm this so i can order the right bolt please

Link to comment
Share on other sites
MartinB

MartinB

Posted
Posted

I did know the answer to this Kai but don't know whether I can dig it out again, I will have a look when I get home. It isn't the same as the Meade. Go to the celestron web site and check the knowledge base. My question about this from a few months ago should be in there. Also, from memory the sizes at the front and back aren't the same. Also they are some funny size and not easy to get hold off. Again I might have that info at home.

That's all assuming your bolt holes are the same as my Nextar GPS 8"!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.