Jump to content

NLCbanner2024.jpg.2478be509670e60c2d6efd04834b8b47.jpg

Found ol'stripy


Recommended Posts

The nasty, nasty thing would get sharp and then go out of focus. Seeing was very poor as it was low down and just over the neighbour's houses and the M62. I was going to post two consecutive frames from one of the AVIs but the new 'puter went and died on me. I have thrown the new chairs outside as I have been electric shocks off them. I assumed that something had fried but, after only having to reset the CMOS, it works again. (But for how long?)

Will try to do something for informayion purposes soon.

Captain Chaos

Link to comment
Share on other sites

Same where I am Gordon. The thing gets in focus as I twiddle the knob but goes in and out of focus all the time during the filming. The most annoying thing is that it changes size! I can pick through the frames manually to sort the in focus ones, which is a non-trivial thing for me, but I can't choose the ones that are all the same size!

Driving me mad this "seeing" thing.

Captain Chaos

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.