Myfocuspro esp32 Output expected on Step pin

[Jimboh]

I have been building and testing the esp32 version using the 8825 board config.

I have the display and am able to run the webserver and do a goto and the display shows the position number going from set to goto value.

The problem I am having is no movement whatsoever of the stepper.

I am using a stepper module mount for the 8255 and a nema 14.

I am looking at the step and Dir pins with my scope . The Dir pin is going high for positive moves and low for negative moves. 

I was expecting to see pulses on the step pin but see nothing (0v). I am pretty sure I have everything set up but even having read the manual in full several times I am still not 100% sure.

Can someone tell me what I should see on the step pin on the ESP32?

[Dr_Ju_ju]

Is this one of Robert Brown's designs ??, if so it would be better asking Robert directly on Source Forge (https://sourceforge.net/u/brownrb/profile/) 

[Jimboh]

OK sorry and thanks, I somehow missed his discussion pages. Have posted there.