Jump to content

Banner.jpg.b89429c566825f6ab32bcafbada449c9.jpg

Jimboh

New Members
 View Profile  See their activity

  • Posts

    2

  • Joined

  • Last visited

Reputation

0 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Jimboh
    OK sorry and thanks, I somehow missed his discussion pages. Have posted there.
  2. Jimboh started following Myfocuspro esp32 Output expected on Step pin
  3. Jimboh
    I have been building and testing the esp32 version using the 8825 board config. I have the display and am able to run the webserver and do a goto and the display shows the position number going from set to goto value. The problem I am having is no movement whatsoever of the stepper. I am using a stepper module mount for the 8255 and a nema 14. I am looking at the step and Dir pins with my scope . The Dir pin is going high for positive moves and low for negative moves. I was expecting to see pulses on the step pin but see nothing (0v). I am pretty sure I have everything set up but even having read the manual in full several times I am still not 100% sure. Can someone tell me what I should see on the step pin on the ESP32?
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.