EQMOD help!

[Pryce]

So, as I have just gotten my brand new EQ6-R Pro and I'm starting to test a few things out, I'm obviously running into issues here and there.

The last one is with EQMOD, no surprise there.
I have V200q of EQMOD
EQDIR cable connected directly to the computer
I'm using the EQASCOM toolbox
I did check which comport(COM3) is used and set it to COM3 under the driver setup in toolbox
I set the baud to 115200 as well as the bits pr second under port settings.

I got it to work, for a moment. But suddenly(with no changes on my end) i started getting the "Connect Error: Timeout" message and even after several system resets I can't get it to work.

Suggestions?

 

Edit: I just set the Baud to 9600 in the eqascom setup and the bits per second to 921600 in port settings and that... worked? 

Second edit:

Well apperantly everything works now.  Benchtest complete.  Now I just have to make it work outside as well 😅

Edited November 27, 2020 by Pryce

[Merlin66]

The higher baud rate seems to be used when the new USB port on the mount is used (Not sure about your EQ6-R), otherwise it's the 9600 .