wookie1965 Posted October 7, 2018 Share Posted October 7, 2018 Last couple of times I have used this when aligning stars when just tapping the right key to refine the alignment it drifts for a couple of seconds, all the other buttons I just tap mount moves a tiny bit then that`s it. When I then view objects they are well over to the left and I have to drag them back in and as I go around the sky it gets worse to the point the objects are way out of the FOV. This has now got to the point that when I go for objects I have not seen before I dont know if they are in the FOV I.E doubles I went for Neptune last night and could not see it. Any help appreciated Link to comment Share on other sites More sharing options...
Knighty2112 Posted October 7, 2018 Share Posted October 7, 2018 I guess two things that could be causing your problem are is the scope balanced correctly in both directions, and is it polar aligned well? My AVX goto gives similar issues unless I get both things nice and correct, which adds time to the set up procedure but well worth it. Link to comment Share on other sites More sharing options...
wookie1965 Posted October 8, 2018 Author Share Posted October 8, 2018 Yes polar aligned well and I check balance every time I have been told it sounds like backlash settings Link to comment Share on other sites More sharing options...
Knighty2112 Posted October 8, 2018 Share Posted October 8, 2018 Is there a way of setting the mount back to its default settings and see if that cures the issue? Link to comment Share on other sites More sharing options...
Synchronicity Posted October 8, 2018 Share Posted October 8, 2018 Does the motor continue to run and drive it too far? If so it could be a sticky key on the controller. I've not seen one stripped down but some devices like this have contacts on a circuit board with sprung or elastic pads that are pushed onto them. These can get sticky with age. Michael Link to comment Share on other sites More sharing options...
Stub Mandrel Posted October 8, 2018 Share Posted October 8, 2018 7 hours ago, wookie1965 said: Yes polar aligned well and I check balance every time I have been told it sounds like backlash settings I would expect that if the RA backlash was set too high, so it's over-compensating Link to comment Share on other sites More sharing options...
wookie1965 Posted October 8, 2018 Author Share Posted October 8, 2018 Just checked Ra motor and there was a bit of slop in it. I have eliminated that with trial and error just need try it out again now hopefully this has sorted it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.