3d printed cable holders

[kbrown]

A quick design and print to get those cables running down the scope organised a little nicer. These go over the standard Sky-Watcher tube ring bolts on my 250PX without affecting their performance. Previously I've just hanged the cables off the bolts directly but it always felt a bit so and so.

 

[Chriske]

Nice one...! For a temp arrangement like this, an ideal solution...
I have something similar. Mine is used to arrange wiring in a printer itself. It is very small and use tie-wraps instead.

[steppenwolf]

Much neater than my kitchen food bag twist ties!!

[Chriske]

8 minutes ago, steppenwolf said:

Much neater than my kitchen food bag twist ties!!

But it does the job too, not...?