Artemis Capture Sequencer

[LongJohn54]

As usual it's raining so I've got the NEQ6 and scope set up in the bedroom looking out over the rooftops.

Just spent an hour getting focused on a chimney about a mile away and then getting the guide camera focussed on it too.

Decided to try the filter wheel and set up a sequence of exposures but have hit a problem. The Run button on the sequencer isn't enabled. I can take individual subs and move the filter wheel by selecting its position in Artemis Capture but not do it automatically using the sequencer.

There must be something simple that I've missed but I've missed it! Help!

John

[jnc71106]

The run button is greyed out if your looping the camera. Could be that

[LongJohn54]

Thanks. I think you could be right. I still had an image on the main screen whilst I was setting up a sequence.

This was the first time I tried out the full imaging setup and was quite happy that I'd got everything talking to each other on the laptop.

I'll have another go tomorrow.

John

[Davey-T]

It's a while since I used it , but I think I used to save the sequence with a name and then load it and use it, don't know if you can omit this step.

Dave