Jump to content

Banner.jpg.b83b14cd4142fe10848741bb2a14c66b.jpg

flip mirror question

northcanadian

Recommended Posts

northcanadian

northcanadian

Posted
Posted

Hi folks:

I was going to attach my flip mirror (finally) to the SCT but need to adjust the tension to hold the mirror up.  It's a Meade model 644. I have the allen wrench to remove the knob on the one side, unfortunately I lost the allen wrench to remove the side plate to access the tension adjustment screw. The side plate set screws are smaller size than the set screw on the knob....so small I can barely see them.  Would anyone happen to know the size allen wrench these would take?

Thanks again

Cheers

Roger 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.