Enhanced dual axis motors for eq3-2 mount issue

[Wifefang]

Hiya all, I had almost given up trying to guide my camera as couldn't get past calibration in phd2.  So I thought I would disconnect the declination motor and see if I could get calibration to complete in ra axis. I since discovered that the Manual guide mode dosn't seem to correspond to ra and dec axis as they should. South pulse and east pulse controls my ra motor? I believe that east and west should correspond to ra axis? Am I correct to assume that the st4 port has possibly been wired wrong at the factory? Can phd2 be configured to fix this problem. This is a weird one. Thanks in advance and any help would be greatly appreciated

 

Thanks again gary