I am intermittently getting the following error message:During the start-up countdown after step 27Err Model Num -
"The telescope model not be read".And intialization cannot proceedThen the handset hangs.If it does get past this stage, then it will not always find the StarSense camera or wi-fi module.These are the current Firmware settings - when the scope is working.StarSense HC on Link: SERIAL using portal: COM3Boot Version = 3.2.5190Wifi Accessory Bridge on Link: PTE_HC using portal: Wifi Accesssory BridgeApp version = 3.1.9120StarSense Accessory Camera on Link: PTE_HC using portal: SSA cameraApp version = 1.2.13343If i power up with the camera disconnected it will the load and wait for camera.I then plug the camera in and it works ok at this point including the Wi-FINote:It is running on the base 2 AMP power supply.
Any thoughts/suggestions?
Thanks