whipdry
-
Posts
367 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Status Replies posted by whipdry
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Hi Bill,
I like the design of 3d prints, hopefully one them will give the result you need.
Seems the rain sensor board has has adjustment for sensitivity... can't remember ever changing mine, I just set both the Wet & Dry Threshold sliders to 80%
Not sure where you sourced your project box, mine was described as waterproof but the supplied lid seal leaked & screws went rusty!
Any chance you can tell me exactly where in the code you made the changes?
Cheers
Peter
-
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Had the same issue when I first tried mine, I'll sort out a picture of my improvised solution & post it here... sometime later today!
At the time I found a garden hose to tap connector that has split (see picture), inverted with the rubber seal removed I found using thin wire held it in place... as you can see the setup has weathered badly!
Something similar in black plastic or rubber should do the trick, just need to get the apeture right & make sure you have drainage!
-
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
Hello Bill,
Just tested my Arduino without the sensors connected & get the same error you're getting (I'm using SGPo)... once you have all your components do a pre-build test & let me know if you still have issues.
Peter
-
I'm only using it as a monitor as my ROR only just clears my parked mount when opening, it's only millimetres!
For some reason the IR sensor reading was way out when first tried it, from memory something like minus 180C. With trial & error managed to sort this by restricting the veiw & eventually got it within the safety monitors range.
It's possible to adjust the IR sensor firmware but never sorted how to gain access!
Peter
-