Celestron CG5 ASGT - All Star Polar Alignment
CG5 All Star Software Polar Alignment
I have always used a Polar Scope to set up equatorial mounts for imaging. When I heard about
Software Assisted Polar Alignment I was skeptical. I was skeptical because during star alignment I have often found
alignment stars to be fairly off centre and occasionally outside the field of view. However this was happening
with my C8 partly due to having to rotate the 2" Diagonal every time the OTA moved to a new star.
When I rotated the Diagonal, the star would shift noticeably in the Field Of View.
After upgrading my Hand Controller to Version 4.16, I decided to give the new All-Star Polar Alignment a try.
I performed a 2 star alignment with 1 Calibration star. The stars were Sirius, Procyon, Rigel. Procyon was the calibration
star and I was pointed at Procyon when I initiated the Polar Align Routine. The routine is now accessed by pressing
The Align Button on the hand controller. The hand controller prompted me to centre Procyon in the eyepiece then press Align.
I did and the scope then re slewed to Procyon. But this second slew moved the scope to where Procyon should be if the mount
were accurately polar aligned. Now I moved the scope back to Procyon by using only the Altitude and Azimuth adjustment knobs on the mount. Its best if you put the hand controller down during this phase - the temptation is too great to tap the direction buttons as you normally do when aligning on stars.
I had initially used the polar scope to put Polaris in the centre of the Polar Scope. This way I knew my alignment was already close so there should not be any large correction required. When the scope re slewed to Procyon, it was off target by at least as much as two moon widths. I scoffed at this and thought the calculation must be way off. But I thought I would complete the test anyway.
I gradually moved the scope back on to Procyon using the mount adjustment knobs. This took around 5 minutes. I took off
the Polar Scope cover and looked for Polaris. I did not expect to find it in the field of view. But in fact it was positioned
just outside the small circle for Polaris in the Polar Scope. I was surprised at this mainly because it seemed I had moved the
telescope a lot to align on Procyon. I looked at the orientation of Cassiopeia in the sky and compared with the Polar Scope
and realized if I rotated the mount to match the sky view - Polaris would indeed be inside the small circle.
From this I realized the Polar Scope has a much wider field of view than I expected. This means in turn that any error in
placing polaris using the Polar Scope is much larger than it appears. The opposite is also true, that the main scope has a
much narrower field and therefore potentially a much higher accuracy in placing Polaris.
I did then take some images and found tracking to be good. My timer had a low power malfunction and set all my exposures
to 30 sec instead of the 60 sec I had programmed. I was therefore not able to compare directly with previous longer image
runs. Out of 40 images though, 38 were un trailed at 800mm and 30 seconds.
This test has caused me to reverse my opinion on this one. I had been confident the Polar Scope would be more
accurate. But now having seen how wide the FOV is in the Polar Scope it should be possible to easily improve on
this by carefully using the SW Polar Alignment.
2 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now