EQ6R-PRO polarity of power connector

[bemo47]

Hi,

I have a new EQ6R PRO mount to install in my observatory, replacing the previous EQ6.

I need to connect it to my internal 12V power by using the car jack connector provided, like for the previous one i will just cut the cable and connect the 2 wires to my 2 12V wires.

But i don't see any indication shownig were is + and -, and if i remember well these mounts are not protected against an inversion of polarity, so i must be careful...

I am sure there should be a topic here in the forum, but if someone could give me some indication it would be a bit faster...

I am assuming that + is the center connector on the car plug delivered with the mount, is that right ?

Thanks for any advices ,

Bernard

[Anthonyexmouth]

yeah, pretty much everything is tip positive these days, i do come across some wacky cheap stuff that is tip negative and also some old stuff but its rare. 

[bemo47]

i just found this drawing in the manual, i didn't noticed it before :) i think i have the answer here...