2" filter cell for 36mm unmounted filters

[RuralBill]

Hi,

not sure if this is the right place to post this, if not I am sorry

i have a set of Baader 36mm unmounted filters, and wondered if there was any such thing as a 2" filter cell to hold these so they can be used individually, I know that you can get 2" cells for 1.25" filter to screw into.

i would think that it would be a good idea if it has not already been done, as my focuser on my small frac, is just not up to holding the full weight of my mono CCD (Atik 383L+) camera and USB filter wheel, I was wanting to use the filters seperately to save on weight, I know that thre are filter slides and drawers, and such like but they all add weight.

maybe such a thing could be 3D printed, I have some spare blank 2" filter cells, just need to design a holder to fit them...

Any ideas ?

Bill