EQ5 Goto - what wire goes where?

[Dara]

After a week of looking at two large boxes sitting in the hallway, I've finally managed to get the time to put together our 200P on an EQ5 Goto.

The tripod/telescope instructions are a tiny bit disappointing but I think I'm muddling through them. However, there seem to be no instructions at all concerning the goto handset and related kit. I'm trying to be un-blokey and not just stick cables into potential places and seeing if it works or not!

My assumptions are as follows -

Obvious one -

cat 5 (or is it 6?) looking wire goes between left socket on bottom of handset and 'hand controller' socket on, er, main box.

Less obvious -

cable from top of main box goes to RA In socket on mount?

cable from Dec Out on mount to Dec In on mount?

There are two places the power cable could go - into the bottom of the handset or the front of the main box. I'm assuming it's the latter?

Are there any online instructions for the use of the handset?

[altec]

hi dara

click on this link

http://stargazerslounge.com/beginners-help-advice/175253-help-connecting-synscan-goto-eq5-mount.html

if you look at the pic on the link you will see that the power cable is connected the the handset

this is wrong it should be connected to the main box

[kharga]

Try http://www.opticstar.com/download/Astro/Doc/mounts/Skywatcher/SkyScan-manual.pdf

[Fluxgate]

Yes, you spend all that money on a scope, then the ?instructions, what there are of them, are written in pidgin English and leave much to be desired.