Hello everyone. I am wondering whether anyone could point me in the right direction on a collimation issue I am experiencing with my SW Explorer 150P. Very likely (almost inevitable) this is user error, but having read as much as I can, including Astrobaby's guide, I cannot for the life of me figure out what I am doing wrong in relation to secondary mirror placement. I am very much a novice so take what is said below with a pinch of salt.
The issue is this: I cannot centre the secondary under either a collimation cap or cheshire combi tool's crosshairs, as there is not enough travel in the centre screw of the secondary mirror to bring it far enough to the right (as you look down the tube - i.e. to 3 O'clock). I have obstructed the primary as recommended with a piece of brown card, and placed a sheet of white paper opposite the focus tube.
The secondary is pretty much screwed into holder (i.e. there is probably the best part of 3mm or so between the secondary holder and the spider), and the mirror still on my view needs to come further over to the right hand side (considerably so when looking through the sight tube). It feels to me that the focuser has been installed too high on the OTA or alternative is considerably out of collimation itself.
Some pictures below and attached to illustrate. I am wondering what on earth I have done:
1. View through the collimation cap;
2. View through sight tube (sight tube pulled back somewhat to expose all of the secondary).
Any responses greatly appreciated.