Jump to content

740427863_Terminatorchallenge.jpg.2f4cb93182b2ce715fac5aa75b0503c8.jpg

SYNSCAN problem


Recommended Posts

Suddenly my SYNSCAN handset has gone haywire. It initializes & then says"No link to MC Stand Alone Mode"

Does anyone know what I can do to sort it out please?

What about updating the firmware?

Thanks,

Fay

Link to comment
Share on other sites

Fay, this has happened to me twice and was caused by wires becoming separated inside the RS232 plug on the EQ6 handbox cable. Can you borrow a handbox cable off someone at your club and see if this eliminates the problem? I presume it is your EQ6 that has done this? Either way, I would eliminate the cable first.

Link to comment
Share on other sites

Have tested on another mount Dave. My mount is ok as EQMOD still ok. Done tests on cable with someone else & all was ok. It is the handset that did not work anywhere.

Going to try a firmware up grade later on.

Fay

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.