Jump to content




My Quantum 7.4 mods


Recommended Posts


I just would like to share some of my improvements on the Quantum 7.4 bino.

First of all, I have received it with the nice gold guide scope - which you just cannot adjust properly, it is fix. So replaced its holder by a Skywatcher finder foot, now I can put a red dot finder or another small finder there :( (see first photo ). The screw of the original foot fits exactly, so no drill needed !

By using the scope I discovered an obvious design fault: it is mounted under his center of mass ( see second picture ). Therefore it falls over just in every position unless you tighten the fork bolt firmly. My solution is reusing two Meade Lightbridge counterweights ( 0.8kg each ). They nicely clip on the fork, and there is enough clearence to turn the scope to any position ( third photo ). Now it is almost in perfect balance. It stays in place with just a small tightening, and you can still easily adjust the position without loosening the azimut bolt.

My only concern is still the ocular clamp, since it is not holding very strong ( specially in nerar zenit positions ). I don't find any way to make it stiffer, maybe someone figured out how could it be done.






Edited by jarbi
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.