Jump to content

sgl_imaging_challenge_2021_annual.thumb.jpg.3fc34f695a81b16210333189a3162ac7.jpg

RS232 joiner nuts???


Recommended Posts

I've finally got everything together with the EQMOD/ EQDIR and the HEQ5pro mount running under CdC V3. Looking good, but I have a problem with the cabling.....

The cable from the EQDIR is a 9 pin RS232 plug ( male) and the cable to the HEQ5pro is a 9pin RS232 plug (female) to the RJ45 (?) on the mounting so you end up with a "joint" that has two screws facing each other in the RS232 plugs.... I'm sure you can get a long nut which will let you lock these two together. Can you help? I obviously need two of them..... ( got to be better than Gaffa tape!)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.