Jump to content

Stargazers Lounge Uses Cookies

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic. Continued use of SGL indicates your acceptance of our cookie policy.

Dean

How to measure a telescopes focal length?

Recommended Posts

Hi

I have nearly finished referbishing a telescope that my father built 33 years ago.

Can anyone tell me how i can measure its focal length?

Thanks Dean

Share this post


Link to post
Share on other sites

Hi Dean,

I too am refurbishing an amatuer built truss tube newt. This is how I done mine. You will need a tape measure, a piece of white card and a torch. Remove the primary mirror, prop it up safely indoors (you will need plenty of room for this). Holding the torch in one hand and the piece of card in the other and standing well back from the mirror and (with the card and torch in the same plane as the mirror), shine the torch into the mirror so the reflected light hits the card. Now move forward (or back) until you get a focussed image of the torchlight on the card, place a marker on the floor at exactly that spot. You then measure the distance between the mirror and marker and then double that figure. That should be your true focal lenght.

Good luck

Roy

Share this post


Link to post
Share on other sites

Isn't this method measuring the radius of curvature, which is twice the focal length ? (not half).

I use a similar procedure, but use the sun as the source, reflect the sun's image onto a piece of card, and when in focus, the distance from the card to the mirror is the focal length.

/callump

  • Like 1

Share this post


Link to post
Share on other sites

What sort of scope? If it's a reflector & the mirror is out of the tube, the focal length is half the radius of curvature.

Otherwise the best way of measuring focal length is to measure the diameter of the field stop of an eyepiece very carefully (the ones to use are those with an accessible field stop i.e. Plossl or Ortho, not exotic types where the stop is embedded between the elements). Now measure the length of time it takes for a star to drift exactly across the diameter of the field, with the drive switched off & no manual corrections. The true field width W is then one minute of arc for every (4/cos d) seconds (where d is the declination of the star) and the focal length of the objective can be obtained (near enough) from F = D/tan W.

  • Like 1

Share this post


Link to post
Share on other sites

Thanks for your posts they have all been very helpful.

Thanks Dean

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.