How to Reset EQMod/AstroEQ?

[kman42]

I have a mount with DEC and RA stepper motors, driven by an AstroEQ box and controlled with PHD2/EQMod.

I'm getting a recurring problem where I plug everything in, an it works at first. I'll start EQMod running Sidereal to get some drift alignment going. However after a few minuts the stepper motors make weird noises (eg. the DEC stepper, which should be inactive, starts a constant whine with a rising pitch!?). At this point, the mount becomes completey unresponsive to any EQMod commands. I managed to reset the problem once, but next time I set it up it happened again. Now I can't reset it and can't remember what I did. If I disconnect and reconnect everything, the whines just start back up where they left off. I'm not even sure if its a problem with AstroEQ or EQMod. How do you reset either of these?

[Dr_Ju_ju]

Have you turned on logging within EQMod ?  if so what does it report ? 

For AstroEQ have you run the Config Utilities from AstroEQ (https://astroeq.co.uk/downloads.php) which will reset your device.