Jump to content

Stargazers Lounge Uses Cookies

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic. Continued use of SGL indicates your acceptance of our cookie policy.

stargazine_ep28_banner.thumb.jpg.b94278254f44dd38f3f7ee896fe45525.jpg

Recommended Posts

Hi. I have Celestron CPC 1100 EdgeHD with Starsense and WiFi Module. During the alignment process, WiFi module stops responding, whereas my tablet or iPhone is connected to the WiFi module,  the SkyPortal message pops up that connection is failed and scope isn’t responding? Can anyone help me how t fix this urgently ? It was working fine yesterday but now I can see this message. I though it’s a power issue, so I disconnected the power tank and connected the scope directly to the electricity through supplied adapter, but failed. 

2A06DEF7-63F3-4542-9248-9BCFDB83B2E1.png

AC7E848D-88B7-446B-8939-CCF657C6A0F0.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By JamieHardcastle
      Hi everyone,
      My other half bought me (us) a Celestron 130 for my birthday recently.
      I have watched tutorials and done a lot of reading about collimating and various other tips since alongside several hours peering through the telescope.
      I can achieve a very crisp image of the moon which is awesome. However, trying to get a decent focus on Mars/Jupiter Saturn is proving very frustrating. The only non-blurred image of any of them is a single white-point, non dissimilar to what I can see via the naked eye. 
      i’ve tried both the 20mm & 10mm lenses and adjusted the focus in and out all the way.
       
      Any advice would be gratefully received.
      thank you, in advance.
    • By MountainDog
      I have just encountered an error message which says "NO RESPONSE 16" when I power up my 130slt. Has anyone else experienced this issue?
    • By NightSky_Wanderer
      Hi,
      I am hoping someone here may be able to offer some help or advice. I have submitted a support ticket with Celestron but I am still waiting for a reply and would really like to get this working ready for the next clear sky!
      I recently brought a starsense but have not been able to use it because it comes up with the following errors,
      Err: Model Num
      The telescope model could not be read and initialization cannot proceed.
      Critical error!
      File: ..\source\mo
      Line: 1468
      An unexpected error occurred that may cause the HC to not opperate normally.
      When updating the controller and camera it finishes succesfully but when I check for new updates it proceeds to install the same one again and again.
      I can still control the mount and I think the camera tried to do an alignment in my room.
      I have a Celestron Nexstar 6SE.
      Thanks
      Adz
    • By StarGazingSiouxsie
      Hi, 
      Just thought I'd share this in case you haven't seen it already. A recent (September 2020) article added to the Celestron 'Knowledge Base' on collimating SCTs.
      I don't claim to have seen all articles on collimation, but this is defs one of the best that I have seen. 

      https://www.celestron.com/blogs/knowledgebase/sct-edgehd-collimation-guide
       
      Siouxsie 
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.