Jump to content

sgl_imaging_challenge_2021_2.thumb.jpg.72789c04780d7659f5b63ea05534a956.jpg

Fitting Chroma 3nm narrowband filters into Atik EFW2


Recommended Posts

I am replacing two Baader 7nm filters with two Chroma 3nm narrowband filters, 36mm unmounted into an Atik EFW2.  Have replaced one but am not sure I've done it correctly so before I fit the second one would appreciate some help.  It's a different design from the Baader - deeper  and I haven't managed to get it to fit as flush as the Baader ones?  The Baader filters are mounted on a rubber ring and screws with little white spacers are used to secure the filters so  they are flush.  I've assumed I should do the same with the Chroma filters though the rubber ring is very fiddly to fit - I've just dropped it in until it looked ok and then dropped (gently!!) the filter on top ?   It's all a bit nerve racking thinking about how much I've paid for the filters!!

Annie 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.