Crater Clavius 24/06/2018
-
Recently Browsing 0 members
No registered users viewing this page.
-
Similar Content
-
By Marsto
Hi
I am looking for help and advice on my SynScan EQ5 pro problem which i am struggling with. Everything was working fine and as expected. I have never updated the firmware and thought while i had everything connected i would update the Hand Controller and the skywatcher WiFi dongle.
Everything updated first time without issue and i was pleased to be up to date. However i loaded SynScan app on the pc which connected fine through the handset and USB/Serial adaptor cable. I clicked on the movement arrows and nothing happened, i then went in to a random 1 star alignment and again no response from the motors.
I powered off again and instead of the PC i tried the hand controller, i tried a 1 star alignment and the hand controller was displaying the slewing but again no response from the motors. in panic i then did the same with the WiFi dongle and phone app, same thing the software is showing movement but the scope remains still.
Knowing all was well prior to firmware updates i reverted back to the previous firmware version and no difference, i tried it again in Lo mode and still nothing. I then noticed a firmware update for the Motor Control so thought i had nothing to loose i updated the Motor Control firmware and again no sign of life from the Motors. I have swapped the cables around, checked that they are all inserted correctly, the power is from mains not battery and the power source is plugged in to a a Power Filter and Surge protector.
I have little experience of circuit board electronics, i was struggling to find similar experiences online other than voltage issues due to batteries which is not the case. I have opened it up and no obvious loose cables of solder loose, but this was straight after the firmware update which seemed to have installed and updated very smoothly no crashes etc.
Any help would be really appreciated.
-
By Del Russel
Hi guys,
I wonder if anyone is able to help me.
Recently bought the ZWOASI224c and connected it to my SW 80x600 appo doublet unguided. Have taken videos and stills of Jupiter and processed with Sharpcap, AS and Registax but the results from Registax are appauling.
Have been using this scope with a x2 Barlow and my Panasonic GX8 and getting very reasonable results so dissapointed with the ZWO so far.
Any suggestions would be most appreciated, thanks in advance. Images to follow
-
By Aussie Dave
Crater Clavius taken on the same night as before, different video, smaller ROI, the best from the night.
Saxon 8" Maksutov, SkyWatcher EQ5, ZWO ASI224MC. Captured in SharpCap, stacked in AutoStakkert, wavelets in RegiStax, edited in PaintDotNet. Conditions good from Mandurah, Western Australia.
5505 frames captured from a 3 minute video, 25% (825) best frames stacked.
-
By Aussie Dave
Saturn from the 23rd of June 2018.
Captured in SharpCap, stacked in AutoStakkert, wavelets in RegiStax, edited in PaintDotNet.
Saxon 8" Mak, SkyWatcher EQ5, ZWO ASI224MC with Tele Vue 2.5x Powermate. Conditions poor to average from Mandurah, Western Australia.
-
By Aussie Dave
Jupiter and two moons from the 18th of May.
Captured in SharpCap, stacked in AutoStakkert, wavelets in RegiStax, edited in PaintDotNet.
Orion Starmax 90mm Mak, SkyWatcher EQ5, ZWO ASI224MC with a Meade 2x Telenegative. Imaged from a suburban backyard in Mandurah, Western Australia. Conditions poor to average.
-
Recommended Posts