Jump to content

Stargazers Lounge Uses Cookies

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic. Continued use of SGL indicates your acceptance of our cookie policy.

imballinger

Collimate - Noob question

Recommended Posts

I'll leave the experts to tell you, but my Celestron may as well have come as a kit! The secondary mirror was barely hanging on the central adjuster! It needed full collimation. Quite disgusting really as some youngster could've received this and had no idea how to collimate, not that I did either as I had to learn, but I'm very good with technical bits and got it done.  

Share this post


Link to post
Share on other sites

Read this PDF attachment.

 

Share this post


Link to post
Share on other sites

The above may not apply to your scope now that I've seen yours is a different type, sorry!

Share this post


Link to post
Share on other sites

Why do you think it needs collimating? Do you have an optical issue? Unless there is a very good reason to do so I would leave it well alone.

  • Like 2

Share this post


Link to post
Share on other sites

I didn't think it needed it, Just read in the instructions that it may need doing, What would the sign's be that it needs doing? When we do get clear sky's I am going to test with the unfocused method.

Share this post


Link to post
Share on other sites

Hi imballinger 

yes, SCT scopes do require collimation!

but it is very INFREQUENTLY required as they hold collimation very well.

you can tell when it needs doing by doing the following.

- select a bright star

- put your HIGH power eyepiece in, x300 is a good magnification but put in the lowest mm eyepiece you have.

- centre the star in the view

- defocus by a QUARTER turn of the focus knob

= you should see diffraction RINGS appear around the star. If the rings are even and  nicely circular then collimation is fine. STOP

if the rings are UNEVEN and tighter on one side then collimation is required...

 

there are THREE SMALL SCREWS on the secondary mirror in the middle of the FRONT of your scope. These are collimation screws. Tightening them by VERY SMALL amounts 1/10 turn changes the mirror angle and alters the diffraction rings you see.

 

if your scope needs collimating there are plenty of good guides on this forum, search for "collimating SCT"

 

Alan

Edited by alanjgreen
  • Like 1

Share this post


Link to post
Share on other sites
On 03/01/2017 at 17:11, imballinger said:

This may be a stupid question, I have a Celestron Nexstar evolution 8, does it need collimating?

Hi - as a new owner of your telescope I can recommend thread I started about Jupiter being blown out. Not for its author sadly but for all great advice I got on this site re. Collimation for the scope.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.