Jump to content

sgl_imaging_challenge_2021_4.gif.6a323659519d12fc7cafc409440c9dbf.gif

Help making a Worm gear housing!


udaiveer
 Share

Recommended Posts

U managed to get a 28t gear driven by a Worm Gear set.

Managed to weld (2) nut for 6mm bolt.

With a temporary setup I am get 1/2RPM. Yup 2mins per rotation. That i can up by removing a gear from the DC motor gearbox thats outputting 15 to 3 RPM. The motor n gearbox are actually 30rpm(i added a 4:1 reduction gear).

Photographs on my blog.

Right now hilding the worm in place using 2 thick washers.

Need to get proper heights for all washers n brackets.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.