Jump to content

sgl_imaging_challenge_2021_2.thumb.jpg.72789c04780d7659f5b63ea05534a956.jpg

Recommended Posts

I have an A4 panel that i'm using for my 8" newtonian and it works pretty good, it's just large enough for an 8". The panels light isn't really even on the edges so might cause some problems if not cropping the edges so going for A3 would probably be better, but they are much more expensive.

I'm upgrading to a 12" newtonian and i have ordered an A2 panel to use with it. Better that it's too large so the light is as even as possible.

post-17296-0-84975400-1422536312.jpg

Link to post
Share on other sites

I recently made a flats light box using LED's and tracing paper. The paper spreads the light out and gives for a very nice even field. Im pretty sure you could apply the same logic to a light panel, if you can get A3 tracing paper :D

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.