DSS Help please

[Johnboy2011]

I am using LRGB data for the first time and I'm a bit stuck. I have registered and stacked the luminence data with the luminence flats and bias frames. i am trying to do the same now with the red lum, red flats and bias but get the error message "The checked picutures are not compatibles".

Do you know where I'm going wrong, I'm guesssing it is simple?!

Thanks,

John

[Tim]

Did you bin the colour?

It will likely be a size of the image issue, eg binned coloured but not flat or bias etc

[lensman57]

I am using LRGB data for the first time and I'm a bit stuck. I have registered and stacked the luminence data with the luminence flats and bias frames. i am trying to do the same now with the red lum, red flats and bias but get the error message "The checked picutures are not compatibles".

Do you know where I'm going wrong, I'm guesssing it is simple?!

Thanks,

John

Hi,

I have only had this issue once in my short foray into imaging and it was to do with mixing the raw and Jpeg frames together, the sizes were different. Check the frame sizes.

A.G

[Johnboy2011]

Sorry yes i have binned, luminance is 1 x 1 but RGB is 2 x 2.

What do do next?!

Thanks,

John

[Johnboy2011]

Just to clarify it is just the RGB which is binned 2 x 2, luminence, flats and bias are 1 x 1.

I assume there is a way around this in DSS?

Thanks,

John

[Johnboy2011]

Ah, thinking about it is the problem that I shot the RGB flats 1 x 1 and not 2 x 2 to match? If that's the case I suppose I should re-shoot them at 2 x 2, also I would need a set of Bias 1 x 1 for the luminence and another set at 2 x 2 for the RBG?

Am I on the right track?!

John