Jump to content

sgl_imaging_challenge_2021_annual.thumb.jpg.3fc34f695a81b16210333189a3162ac7.jpg

Primary secondary screws


Recommended Posts

Personally I would not take the secondary out unless absolutly nessercery. Have you tried loosening the center screw/bolt? This may help but you may rotate your mirror (not a problem just means a bit more work to get it aligned again)

The first time I did mine I did have to apply a little more force than I was comfortable with. Im not sure if they use some sort of thread lock solution during production perhaps.

Edited by Nova
Link to comment
Share on other sites

I have never ajusted mine and all of the are too tight for me to undo. I have taken the mirror out to try and get it loose but its stuck solid. The adjusting screws are also stuck tight with is a pain as well. Looks like it will need to go in a clamp

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.