Search the Community
Showing results for tags 'wifi alternative'.
Found 1 result
Can it be done? Without any programming skills? Yes, it actually seems that way... THIS WAS TESTED ON AN SW AZEQ5 mount which communicates with the handcontroller on a 3.3V TTL LOGIC. CHECK YOUR MOUNT'S MANUAL FOR 3.3V compatibility (should be azeq5,azeq6,eq6rpro,eq8), although I suspect it will work with the other 5V TTL logic mounts since the DT-06 board appears to be 5V tolerant, but CAN'T CONFIRM Ingredients: - DT-06 Wireless Serial TTL WiFi board - RJ45 ethernet cable -5v power supply (or 4x1.2v AA batteries) First, take the ethernet cable and cut it in half. Strip the cables and identify the cables to the corresponding pins. Then I consulted SW azeq5's user manual hand control port's pinout. In my case the pinout is as follows: pin1: orange-white ---- ground pin2: orange ----not used pin3: green-white ----not used pin4: blue ---- ground pin5: blue-white ----mount Tx to controller Rx pin6: green ----mount Rx to controller Tx pin7: brown-white ----- +11 to+16 V pin8: brown ----- +11 to+16 V Then I connected the orange-white & blue cables to the DT-06 Wireless Serial TTL WiFi board's ground pin, the blue-white cable to the DT-06 Wireless Serial TTL WiFi board's Rx pin, the green cable to the DT-06 Wireless Serial TTL WiFi board's Tx pin, and a 5V power supply to the DT-06 Wireless Serial TTL WiFi board's ground & Vcc pins (or 4x1.2v AA batteries) , I 've ordered a buck stepdown converter to utilize the +11 to+16 V from pins 7&8 to power the module, but for now I just wanted to make sure it works! Now that the hardware connections are done, we move on to the settings. Power the module and a led will confirm it's on. It is on AP mode so scan with your phone for wifi, and you 'll see something like DoitWiFi_xxxx. Connect to it (no password was set on mine). Open your browser and type 192.168.4.1 , this will take you to the Built-in WebServer where you set the parameters for the module. You will see three tabs: "status", "module", & "more" From the "module" tab's dropdown menu, select "serial" and enter the values : baud rate:9600, databits:8, parity: none, stopbits:1, serial split timeout : 200. Click save. From the "module" tab's dropdown menu, select "wifi". Here you can change the SSID name (I put Synscan), and set a password if you like (I don't). Click save. From the "module" tab's dropdown menu, select "networks". Change the "socket type" to UDP server, and assign UDPserver port to "11880". Click save. Then from the "more" tab's dropdown menu, select restart. Now you 'll have to re-join the network under the SSID name you 've given. I 've only encountered some connection problems related with the serial split timeout. I found a stable connection when I set it at 200ms at the module's Built-in WebServer, and 400ms as the Readtimeout on the synscan app. That's it, you 're set to go. Download synscan pro app and skysafari plus or pro and I 'll post the settings in those apps in my next post.