Search the Community
Showing results for tags 'pulse guiding'.
Found 1 result
Hello. I have an unusual problem with my AZ-EQ6. I decided that I wanted to try pulse guiding rather than ST4, to get rid of a cable. I use MaxIm for all my controls, capture, guiding, pointing etc. and I use the EQMod ASCOM scope driver. My initial pulse guiding efforts worked ok, the mount would move and guide etc, no worries. I was not pleased with the pulse guiding results after some fluffing around so I moved back to ST4 and this seems to be where my issues started. Now, whether I choose ST4 or pulse guiding, my mount will no longer calibrate in the Y axis (Dec, I believe), or for that matter, guide. I have tried the move commands from inside MaxIm guide tab and X responds to a 10 pixel move but not Y. I tested with both PHD 1 & 2 with the same results. If it were a hardware issue, as in the mount has a Dec problem, would I be able unable to operate the mount with the hand controller or on screen motion buttons, both of which slew the mount fine? I could understand if the guide port were malfunctioning that ST4 would possibly have an issue but not when the mount slews as directed, so pulse guiding should work. Could it simply be that my EQMod driver has got confused and needs to be re-set, or am I looking down the barrel of sending my mount back to the dealer? Does any of this make sense? Thoughts and feedback most welcome.