Search the Community
Showing results for tags 'dead zone'.
Found 1 result
Hi guys, This is my first post in here and apologies if someone has asked this question already but I have searched the forum for this answer and couldn't find one. So the problem I have with my mount is that there is a few seconds lag (1-2 seconds) to control input on both RA and DEC axis when I switch the control input to the opposite direction. It happens when I use both the Skywatcher Dual Axis Motor drive kit or even the manual precise controls. There is a slight "give" in the mount when I move it by hand from side to side. It just seems sloppy, like there's too much room between the moving parts inside the mount itself. My questions: Is this "give" normal? Can I fix it? Thanks for reading