Search the Community
Showing results for tags 'carry-all'.
Found 1 result
I just finished a transport box for my Edge 8" and AVX mount. I'd built a similar setup for the C6 I have, I wanted something I could use to store the telescope and mount in that would protect it, plus have something to make it easier to transport when going afield for viewing or AP. This is made from 1/2" birch veneer plywood, it's nothing really fancy, just butt joints, glue and brass screws . I wanted it to remain more utilitarian than "furniture", but dressed it up a little with brass hardware and a nice stain and polyurethane finish. It's in two pieces to make it easier to lift and pack into a vehicle; one box for the OTA, the other for the mount and accessories. These two boxes clamp together and fit on a small hand truck that can be used vertically or horizontally. The tripod I plan to get a bag for, and will strap it to the outside somehow, and all my EP and diagonals are in a separate case. The only other thing I'll have to hand carry is my dew shield. The OTA box is padded with foam rubber cut to fit and covered in a heavy upholstery fabric, the mount uses the large closed-cell cutout that it came shipped in, I dimensioned the box so it would slide in or out, so I can still use the cutout if I ever have to ship the mount for repairs, etc (hope not). Both the OTA and mount have retaining straps with quick-release buckles. Alongside the mount are compartments for gear; I have the counterweights, dew heater, controller and power cord for the mount, the finder scope for the OTA, a couple of field books and my notebook and manuals, and an accessory weight for the OTA. There's still room for other stuff, and I suppose it won't take me long to fill it up. The last picture shows both carriers. The one for the C6 will also carry the tripod.