Mcrogers1
-
Posts
55 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Posts posted by Mcrogers1
-
-
Man, tried doing a PointXP run and each cal star it would slew to I would get a alt/dec encoder error and tracking would stop. Hit start again to get tracking but after each slew the error would trip again. Encoders are set to polite. Going to try a few things Lucas told me to do and Dan at Sitech.
-
Will do.
-
Thanks, Singlin. I'll try this.
-
Hello,
I get a below horizon limits message in the Sitech window no matter where my scope is pointed. This prevents the scope from being able to initialize and start tracking and I have disabled using the horizon file under mount parameters. Tried blind tracking and no change. I can't figure out why I'm getting this error. I used Steve Richard's guide for setup.
Any advice would be appreciated.
Mike
-
On 2/2/2017 at 07:06, Zakalwe said:
Use a Geoptik saddle but take the knobs off and replace with Allen bolts
http://www.rothervalleyoptics.co.uk/geoptik-universal-dual-load-mounting-saddle-plate.html
I just ordered the same plate and would like to know what size allen bolts you use and how long they are. Thank you.
-
Congrats on your mount! What saddle plate are you using? I'm going to a single scope setup until my refractor issues get resolved. All the ones I have locally are too close to the mount to allow you to tighten knobs.
Thanks.
Mike
Mesu 200 Below Horizon Limits
in Discussions - Mounts
Posted
Thanks, Singlin. I think I did have a cable snag because sometimes the model runs fine without any errors. Have to figure out a way to secure them better.