Jump to content

sgl_imaging_challenge_banner_31.thumb.jpg.b7a41d6a0fa4e315f57ea3e240acf140.jpg

johnbaz

Members
  • Content Count

    74
  • Joined

  • Last visited

Community Reputation

250 Excellent

About johnbaz

  • Rank
    Nebula

Profile Information

  • Gender
    Male
  • Interests
    All things with lenses, Guns, Guitars and machinery!
  • Location
    Sheffield, England

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. A few recent additions! I got these off ebay and described as 'Working well', In truth they were far out of collimation, I messaged the seller, Then again a week later and gave another week but no reply so I left negative feedback and put a claim in for my money back, It happened a couple of weeks later, Last night I was pondering putting them in the bin but had a look through my loupe to find the adjisting screws, Found two and uncovered the black plastic from them, I couldn't find the other two on the underside but I noticed that there was a slight gap where the left objective bell screws
  2. Well! I had a go and they were still doing it with the shaft out!!, I put a small amount of oil on the tube and it seemed to do the job! For five minutes!!, It needs the whole tube taking apart! I'll wait until East Coast repairs are taking work again although i've had OptRep recommended recently so may have to get in touch with them!! Regards, John
  3. They look identical, I nay have a go now!! Thanks, John
  4. Hi Dave Both parts look to be nicely tight and moving squarely fore and aft, They will actually get past the tight spot with a bit of extra umph but I dislike forcing them!, It appears that the shop I found has actually closed down, I looked on the google maps and it's just not there any more (Signs are removed from the shop front), Couldn't even find the website when I looked for it again! - If it wasn't for bad luck i'd have no luck at all!! I'll wait and find someone else as I opened a set up years ago, They went in the bin!! I used to take watches apart, Clean them in a parts
  5. Hee hee!! Sounds good Ash I can reacall when I was quite young using copydex on sofas and chairs that had got damaged in the warehouse although they had a hot welding contraption for vinyl but no one knew how to use it!! It always did a good job, I wonder if it's been changed now due to COSHH or something, It was in the mid 70's I worked there!! Regards, John
  6. Hi all A couple of weeks ago I bought a Swift Audubon Mk2 binocular locally, I tried them at the house and they were bright and crisp, The focus was very smooth but as soon as I arrived home and looked down the garden, The focus developed a stiff spot which became quickly to a full on jam!, It seems to me that something is stuck in the threads of the shaft, maybe a bit of muck held in the grease! Has anyone split binoculars on the shafte before?, I'm wondering if i'll do them in completey if I try to clean and re grease the shaft!! I found a shop locally that say they repair binoculars b
  7. Hi Ash Glad you didn't use the cammo tape as if you put them down in the field, You'd probably never find them again!! Years ago I worked at a furniture shop, Carpets and fabric repairs were glued with Copydex, I just googled it and it was also stick metals so it's safe to say that it will probably stick fabric to the aluminium tubes!, Also, I wonder if the leather used for book binding is thinner than the stuff you bought?, May be easier too apply, That said, I think you did a good job with the black tape John
  8. I have a Skymaster 25x70, Whilst it's quite lightweight and easy to hold, The 25x mag is hard to keep still enough to hand hold!! I also bought a Swallow 15x80, These are quite heavy compared to the Celestrons but a little more steady, The image is much less lively! John
  9. I think someone may have messed with these as the nearest focus is around a hundred feet! Beyond that they're fine!! Cheers, John
  10. Hi all Had an amble around the local bootsale last week and dropped on these Swift Trilyte 8x40 for the princely sum of £10 I feel sure they've been in the case for most of their life as the condition is very good!! John
  11. Ahh, Thanks, Pretty sure I have a 90° prism somewhere!, I'll try and find it tomorrow! Cheers, John
  12. Hi all Dragging up an old thread, I decided to take the lenses out to clean them as they were stained and I recently bought an adapter so I can use my 1.25" lenses in the .965" tube! It was a fair old job unscrewing the part that carries the lenses!! The stain from condensation between the lenses! The lenses were quite tight in the tube and when I put them back in, They scraped small bits of black paint from the inside which ended up between the lenses, Had them out several times but got fed up as they scraped the paint off every single time, Can see two bits at
  13. Hi Ruud I had a couple of these focus free, The first ones (Jason perma focus, A company owned by Bushnell) I gave to my lad as I couldn't focus at all through them, I never thought to try looking through my glasses with them!, Anyhow, My lad could see fine so he had them! I bought another focus free (Dowling & Rowe 7x50), These were only a fiver at a bootsale, Again, I couldn't focus (Bad eyes!!) so I tried through my specs and WOW!!! They were great but they focus at any distance, The others which were the same as it turned out, He still has them and uses them!!
  14. I was warned against buying zoom bins by a mate that's forgotten more about binoculars than i'll ever know, Still went ahead and bought some, He was right!! When I zoomed in, I had to re focus, I've had a few sets now and had the same thing with each set! One set I even had to readjust the eye bell on the right as one lens was in focus but the other was out!! I bought these lovely old Tasco zooms for just £14 at a local antiques emporium, It's best to keep them set on one adjustment and use them as non zoom!! A couple more!! John
  15. Hi David The front focus shaft screw removes to attach a bracket for a tripod, I'll probably not get around to mounting them though!! John EDIT- I thought i'd posted in this thread before but apparently not!! Anyhow, My binoculars are HERE, Don't want to post pics as it caused a bit of trouble last time! It seems i've not kept my Flickr up to date as I bought these last year.. Both are 7x50, One is Tasco, The other is focus free Dowling and Rowe.. I didn't add these old Tasco zoom to Flickr either! Crikey, Here's anot
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. By using this site, you agree to our Terms of Use.