-
Posts
3,483 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Blog Comments posted by Dr_Ju_ju
-
-
I agree, for my DBot, I've arranged a 4 point bolt down bed, which is a 6mm cast ally sheet, which I only need to re-level twice, both times due to replacing the PEI sheet.
-
with all that timber etc, I doubt you'll be able to lift it, let alone move it around.....
-
Gina, just seen this blog, & I'm wishing you all the best....
I have a pond of 50,000 L & have Koi, Shubunkin, Orfe & Frogs etc. in residence with visiting Herons who can't get in as its all covered in netting...
If you need any pointers, just shout.
-
good luck, and let eBay be your friend....
- 1
"GinaRep Concorde" 3D Printer
in A Range of DIY 3D Printers
A blog by Gina in General
Posted
I think you want to check belt tensions and retraction settings, as there appears to be some layer shift, but not every layer, so could be something going on with Z axis movements, but for me, stringing usually means I have to tune extrusion\retraction....