Not sure if I am just doing something wrong but it seems after I setup my system it does not to seem to stay on target. Do I need to press a keep on target button or something. My system is an ADVANCED VX 8" SCHMIDT-CASSEGRAIN TELESCOPE with starsense, gps, with focus motor. I finally tonight was able to setup the starsense and calibrate the camera both ways. Using the hand controller with gps, and then did the setup using WiFi to iPad and using iPad to setup starsence. After setup and calibration of the starsense either of the 2 ways I described then I choose something for to look at and tell scope to go and the scope finds it no problem and the target is in center of eyepiece but after a minute or so it will not stay on target. I was under the impression that when you set it on a destination it is supposed keep on target until you choose another target. Do I need to do something once the scope first finds the target?