Jump to content

Stargazers Lounge Uses Cookies

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic. Continued use of SGL indicates your acceptance of our cookie policy.

sgl_2019_sp_banner.thumb.jpg.a0ff260c05b90dead5c594e9b4ee9fd0.jpg

Leaderboard


Popular Content

Showing content with the highest reputation since 07/10/19 in Blog Entries

  1. 2 points
    Been working on the handset today and I think I'm almost ready to get the parts printed- exciting!
  2. 2 points
    Working on the motor mount this evening- needs a bit more work but the general idea's there. I'm going to use a magnetic coupling and am thinking to make it quick release so I can take it off if I don't want to use it.
  3. 1 point
    24C2AE88-8FBD-47E7-BD34-716FB9018988.MOV Managed to square up the waveform for the step at the expense of halving it’s max frequency But I’ve changed the driver board for the version that actually has half step input so my new max speed is about 3sec/rev which looks ok I think. It’s slmost working how I want it but I need to figure out how to shape the response as it’s too long in the very slow movement then suddenly shoots off into high speed- not sure why as the step times should be linear from the pot Needs some thought Mark (Hopefully the video will load better this time with different codec)
  • Newsletter

    Want to keep up to date with all our latest news and information?
    Sign Up
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.