Jump to content

Stargazers Lounge Uses Cookies

Like most websites, SGL uses cookies in order to deliver a secure, personalised service, to provide social media functions and to analyse our traffic. Continued use of SGL indicates your acceptance of our cookie policy.

sgl_imaging_challenge_banner_dslr_mirrorlesss_winners.thumb.jpg.9deb4a8db27e7485a7bb99d98667c94e.jpg

Sign in to follow this  
  • entries
    8
  • comments
    18
  • views
    228

It’s alive 2!

markse68

555 views

Finally bit the bullet and knuckled down to wiring the handpiece- really made a rod for my own back though with the very tight space for the wires...it’s going to be really tricky getting the other half of the housing on there without squashing wires 🤦‍♂️

But it works-almost perfectly-almost that is except the pwm on the LED isn’t pwming 🤔 I swapped from a nano to the new Arduino nano every and I’m guessing the code isn’t totally compatible...

2D4A492F-BC3D-4A8A-8A00-4FC9DFCEEDDE.jpeg

  • Like 1


3 Comments


Recommended Comments

Doh- should have read the description properly: 

The Arduino NANO Every has the standard ADC and PWM resolutions of 10-bits and 8-bits, respectively. This board doesn't have PWM on D11 and therefore it supports only 5 PWM outputs, as on the Arduino UNO WiFi Rev.2. 

and guess which pin I used for the LED- yep- D11 🤦‍♂️

Still good to know why it’s not working and should be easy enough to fix

Share this comment


Link to comment
Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.